Home / Journals Journal of Electrical and Electronic Engineering / Low Voltage (below 300mV) CMOS Design
Low Voltage (below 300mV) CMOS Design
Submission Deadline: Aug. 30, 2015
Lead Guest Editor
Omid Mirmotahari
Nanoelectronics Systems Group, Department of Informatics, University of Oslo, Oslo, Norway
Guest Editor
  • Yngvar Berg
    Head of Department, Department of Micro- and Nanosystems Technology, Buskerud & Vestfold University College, Kongsberg, Norway, Afghanistan
Guidelines for Submission
Manuscripts can be submitted until the expiry of the deadline. Submissions must be previously unpublished and may not be under consideration elsewhere.
Papers should be formatted according to the guidelines for authors (see: http://www.sciencepublishinggroup.com/journal/guideforauthors?journalid=239). By submitting your manuscripts to the special issue, you are acknowledging that you accept the rules established for publication of manuscripts, including agreement to pay the Article Processing Charges for the manuscripts. Manuscripts should be submitted electronically through the online manuscript submission system at http://www.sciencepublishinggroup.com/login. All papers will be peer-reviewed. Accepted papers will be published continuously in the journal and will be listed together on the special issue website.
Published Papers
The special issue currently is open for paper submission. Potential authors are humbly requested to submit an electronic copy of their complete manuscript by clicking here.
Introduction
Portable electronics drive the need for low power and low voltage due to a limited budget set by a fixed maximum battery mass. Today there is a increase in ongoing research toward embedded circuits in human bodies and the need to harvest energy will become more evident. One of the most fundamental and effective approaches is to lower the supply voltage. When the supply voltage is reduced to hundreds of millivolts, it is known as Low Voltage. However, scaling of the supply-voltage has an adverse effect on the speed of operation of the design. The main challenge is to obtain high speed at supply-voltages that are as low as possible.

Aim and Scope:

1. Low Voltage
2. High speed
3. Energy consumption
4. Power consumption
ADDRESS
Science Publishing Group
1 Rockefeller Plaza,
10th and 11th Floors,
New York, NY 10020
U.S.A.
Tel: (001)347-983-5186