Evaluation on the Fluidity and Strength of Recycled Aggregate Concrete with High Quality Fly Ash as Industrial Byproduct
Journal of Civil, Construction and Environmental Engineering
Volume 4, Issue 5, October 2019, Pages: 87-93
Received: Jul. 15, 2019;
Accepted: Sep. 17, 2019;
Published: Oct. 9, 2019
Views 640 Downloads 190
Chun Ho Kim, Department of Civil Engineering, Joongbu University, Goyang, Republic of Korea
Nam Wook Kim, Department of Civil Engineering, Jeon Nam State University, Damyang, Republic of Korea
This study aims to improve the mechanical function of recycled aggregate concrete that applied high-quality fly ash, which presents relatively stable quality by maintaining loss ignition below 1% by eliminating combustible carbon and obtained following results. As a result of the test according to the changes in high-quality fly ash ratio, as the ratio of high-quality fly ash increased, the liquidity enhanced. From the results of strength development of recycled aggregate concrete, compressive strength increased with increasing age and, when high quality fly ash is added, the Pozzolan reaction indicates a high strength increase even after 91 days of age. On the other hand, the reason why compressive strength is reduced due to replacement of recycled aggregates is that the properties of the recycled aggregate itself are lower than those of the natural aggregate, and it is judged that destruction occurs first at the surface prior to destruction of aggregates or mortar. Compressive strength according to the replacement rate of high quality fly ash tends to increase almost linearly. If high quality fly ash is used in recycled aggregate concrete, it is deemed that up to 28 days, the filling effect by the addition of high quality fly ash and the strength enhancement by the Pozzolan reaction is also exerted in 91 days.
Chun Ho Kim,
Nam Wook Kim,
Evaluation on the Fluidity and Strength of Recycled Aggregate Concrete with High Quality Fly Ash as Industrial Byproduct, Journal of Civil, Construction and Environmental Engineering.
Vol. 4, No. 5,
2019, pp. 87-93.
Copyright © 2019 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/
) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Park, R. S and Bae, J. S. (2007). An Experimental Research on the Quality Improvement of Recycled Aggregates Using Surface Treatment Method, Journal of KSCE, 27 (3A), pp. 421-426.
Rashwan, M. S. and Abourizk, S. (1997). The Properties of Recycled Concrete, Journal of ACI, Concrete International, 19 (7), pp. 58-60.
Nasser, K. W. and Lai. P. S. (2004). Effect of Fly Ash on the Microstructure and Durability of Concrete, Journal of ASCE, 84 (6), pp. 688-697.
Ahn, T. H. et al. (2012). The Strength Property of Concrete Using Modified Fly Ash, Proceedings of KCI, 23 (Autumn), pp. 255-256.
Sawamoto, T, and Tsuji, T. (2003). Effect of Absorption of Colloidal Silica Solution into Repeatedly Recycled Coarse Aggregate on Properties of Concrete, Journal of JSCE, 58 (725), pp. 57-70.
Sim, J. S. et al. (2006). Characterization of Compressive Strength and Elastic Modulus of Recycled Aggregate Concrete with Respect to Replacement Ratios, Journal of KSCE, 26 (1A), pp. 213-218.
Li, G. and Zhao, X. (2003). Properties of Concrete Incorporating Fly Ash and Ground Granulated Blast-Furnace Slag Cement and Concrete Composites, 25 (30, pp. 293-299.
Mangat, P. S. and Khatib, J. M. (1995). Influence of Fly Ash, Silica Fume and Slag on Sulfate Resistance of Concrete, ACI Materials Journal, 92 (5), pp. 542-552.
Sugiyama, Y. (2016). Research on Effective Use of fine Aggregate for Concrete Mixed with Fly Ash, Journal of Japan Architecture Association, 81 (7), pp. 1363-1372.
Mejlhede, J. and Hansen F. (1996). Autogeneous Deformation and Change of Relative Humidity in Silica Fume Modified Cement Paste, ACI Materials Journal, 93 (6), pp. 539-543.
RILEM. (1996). Durability Design of Concrete Structures, Report of RILEM Technical Committee 130-CSL.
Japan Industrial Standard (JIS) A5308.
Jeon, B. H. et al. (2018). Evaluation of the Carbonation Resistance and Properties Ternary blended Concrete According to Replacement Ratio of Blast Furnace Slag and Fly ash, Journal of KCI, 30 (1), pp. 28~30.
Choi, Y. W. et al. (2016). An Experimental Study on Fundamental Quality Properties of Basalt Fiber Reinforced Mortar according to Application of High Volume Fly Ash, Journal of KCI, 28 (4), pp. 387-393.
Yoon, H. S. et al. (2015). Determination of Water-to-Binder Ratios on the Equivalent Compressive Strength of Concrete with Supplementary Cementitious Materials, journal of KCI, 27 (6), pp. 687-693.
Lee, S. H. (2015). Effect of Glassy Properties in Fly Ash on Pozzolanic Reaction, Proceedings of KCI, 28 (1), pp. 487-488.
Jo, U. J. et al. (2015). A study on the unburned carbon removal of fly ash, proceedings of KCI, 28 (2), pp. 491-492.