Experimental and Numerical Study of Free Convective Heat Transfer on the Triangular Fin for the Optimum Condition of Gap's Configuration
International Journal of Science, Technology and Society
Volume 3, Issue 4, July 2015, Pages: 183-190
Received: May 29, 2015;
Accepted: Jun. 18, 2015;
Published: Jul. 2, 2015
Views 5092 Downloads 131
Goshayeshi Hamid Reza, Department of Mechanical Engineering, Mashhad Branch, Islamic Azad University, Mashhad, Iran
Hashemi Bahman, Department of Mechanical Engineering, Mashhad Branch, Islamic Azad University, Mashhad, Iran
In this study, the effect of different conditions for making gap in the triangular fin has been investigated on the free convective heat transfer coefficient. Making gap in suitable places on the monolith triangular fins can increase the free convective heat transfer coefficient, so the purpose of this study is to reach the optimum condition of configuration for gaps by which the free convective heat transfer coefficient is increased. For this purpose, eight different conditions of vertical triangular fins located on a vertical plate were made and investigated. One of these conditions doesn't have gap and the other seven conditions had different kinds of gaps configuration. The obtained results showed that the optimum condition is a condition with the configuration of three gaps on the length of the triangular fin. Also for validation of experimental results, the numerical modeling of all the above mentioned conditions was done by using the fluent software.
Goshayeshi Hamid Reza,
Experimental and Numerical Study of Free Convective Heat Transfer on the Triangular Fin for the Optimum Condition of Gap's Configuration, International Journal of Science, Technology and Society.
Vol. 3, No. 4,
2015, pp. 183-190.
Starner, K.E., McManus, H.N. (1963) , "An experimental investigation of free convection heat transfer from rectangular fin arrays", J., Heat Transfer 85(2), pp. 273–278.
Welling, J.R., Wooldridge, C.B. (1965) , "Free convection heat transfer coefficients from rectangular vertical fins",Trans. ASME J. Heat Transfer 87 (3), pp. 439–444.
Aziz, A. (1985) ," OPTIMIZATION OF RECTANGULAR AND TRIANGULAR FINS WITH CONVECTIVE BOUNDARY CONDITION," INT. COMM. HEAT MASS TRANSFER, Vol. 12, pp. 479-482.
Jofre, R.J., and Baron, R.F. (1986) , "Free convection heat transfer to a rough plate," ASME Paper No. 67.
Kondepudi, S. N., O'Neal, D. L. (1988) , "PERFORMANCE OF TRIANGULAR SPINE FINS UNDER FROSTING CONDITIONS," Heat Recovery Systems & CHP. Vol. 8, No.1, pp. 1-7.
Leung, S. E., Ho, C. W., and Probert, S. D. (1991) , "Performances of heat exchangers with tapered fins".
Abratet, S., Newnham, P. (1995) , "FINITE ELEMENT ANALYSIS OF TRIANGULAR FINS ATTACHED TO A THICK WALL," Computers & Structures, Vol. 51, No.6, pp. 945-957.
Kordyban, T. (1998) , "Hot air rises and heat sink everything you know about cooling electronice is wrong," ASME Press.
Kobus, C.J., and Oshio, T. (2004) , "Development of a theoretical model for predicting the thermal performance characteristics of a vertical pin-fin array heat sink under combined forced and natural convection with impinging flow," International Journal of Heat Mass Transfer 48, 1053-1063.
Nada, S.A. (2007) ," Natural Convection Heat Transfer in Horizontal and Vertical Closed Narrow Enclosures with Heated Rectangular Finned Base Plate", Int. J. Heat Mass Transfer, Vol. 50, pp. 667-679.
Edlabadkar, R.L., Sane, N.K., Parishwad, G.V. (2008) ," Computational Analysis of Natural Convection With Single V-Type Partition Plate", 5th European Thermal-Sciences Conference, Netherlands.
Kundua, B., Barman, D., Debnath, S. (2008) , " An analytical approach for predicting fin performance of triangular fins subject to simultaneous heat and mass transfer," International journal of refrigeration 31, pp. 1113–1120.
Rao, V. D., Naidu, S.V., Rao, B.G., Sharma, K.V.,(2006) “Heat Transfer from a Horizontal Fin Array by Natural Convection and Radiation a Conjugate Analysis”, Int. J. Heat and Mass Transfer. Vol. 49, pp. 3379–3391.
Ji, S.Y. Kim,S, Y, (2007) “Pressure drop and heat transfer correlations for triangular folded fin heat sinks”, IEEE Trans. Compon. Packaging Technol. 30 (1).(2007) 3–8.
Naserian, M.M., Fahiminia, M., Goshayeshi, H.R. (2013) , "Experimental and numerical analysis of natural convection heat transfer coefficient of V-type fin configurations " Journal of Mechanical Science and Technology.